These pics come from a new aerospace test facility that they are constructing at the University of Notre Dame. The SSF-6 is working great.
I am attempting to make all of these fittings air tight as they are used for pressure measurements. We can¹t have any leaks. I had very little warpage of my base metal and I think this is really going to work out very well.
The University of Notre Dame
Institute for Flow Physics and Control (FLOWPAC)
The Hessert Laboratory for Aerospace Research
How to join aluminum to stainless steel. Super Alloy 1 can also be used to join pot metal, zinc die cast, lead, bronze, steel, copper, or brass--in any combination.
Brazing Aluminized Stainless Steel with Super Alloy 5
Two pieces of stainless steel are silver soldered with a propane torch at 1150 degrees.
SSF-6 Silver Solder brazes stainless steel to copper, brass, or steel... in any combination. Can be successfully applied using a propane torch, oxyacetylene, mapp gas or a natural gas torch.
Brazing stainless steel tubing to copper tubing with SSF-6 silver solder using a hand held propane torch.
We used SSF-6 to braze stainless steel tube to a steel plate at over 70,000 PSI with a propane torch..
How to braze brass tubing to stainless steel tubing with a high strength silver solder at 1150 degrees and only using a propane torch.
Joining a brass plate to a stainless steel plate at 1150 degrees with no warpage of the parent metal.
We are using SSF-6 Silver Solder to join two stainless steel plates together at 1150 degrees. The braze was made with a very small amount of silver solder, it doesn't need much as the alloy is over 70,000 psi. A propane torch was the gas used in this video and the solder is flux coated.
We use SSF-6 to solder stainless to stainless with an oxyacetylene torch. After finishing, clean up the flux with water and a wire brush.
SSQ-6 is the perfect solution for jobs like this--parts are balancing, and if a rod were used they could easily be knocked over but the silver solder almost glues them together and acts like a jig when heated.
This deep sea pole has a broken eyelet. We make the repair with SSQ-6 and a propane torch, as well as Cool Blue Heat Paste.
A stainless steel threaded bolt is soldered to a brass nut using SSQ-6 silver solder paste in syringe form.
Using SSQ-6 silver solder paste, Mike silver solders a stainless steel plate to a piece of copper tubing.